General Information

DISH 1000.2 allows customers to receive programming from three orbital locations; 110°, 119°, and 129° using a dish antenna size similar in size to DISH 500. DISH 1000.2 will display 1k.2 as the device and DPP 1000.2 as the LNBF when a Check Switch test has been run.

Dimensions:

• 1 5/8" mounting mast (Slightly longer then the DISH 1000)
• 20.7"h x 25.9"w dish face

Standard Configuration:
DISH 1000.2 includes a DPP 1000.2 integrated LNBF - no switch needed for up to three receivers.
• DPP 1000.2 integrated LNBF; 110°, 119°, 129°


• Connect the three output ports of the DP Plus 1000.2 LNBF to a DISH Pro Plus 44 switch for an additional receiver. When connected to a DPP44 switch using 3 cables, the LNBF provides signal from 110°, 119°, and 129°.


• The LNB input port is disabled if the Integrated LNBF is connected to a DPP44 switch; the 4th orbital in this configuration would have to be connected via the switch..

NOTE: The DP34 and DP21 switches cannot be used in any installation with the DP Plus 1000.2 LNBF.

Valid Receiver combinations include:

• Any DISH Pro or DISH Pro Plus Receiver
• Up to three DISH Pro Plus Receivers each with DISH Pro Plus Separators for the single-cable installation advantage.
• One Legacy Receiver with at least one DISH Pro or DISH Pro Plus Receiver

Receivers NOT compatible with DISH 1000.2: (no 129 support and no fourth orbital location support)
1000, 2000, 3000, 4000, 5000, JVC-IRR, DISHPlayer 7100/7200