The TV2 Converter provides infared (IR) control of TV2 on a two-TV receiver. Currently TV2 can only be conrolled using UHF Pro, and applications that require IR control, such as external Slingbox or most univeral remote controls are not possible on TV2.

Note: This equipment is not available through direct sale; please contact your local DISH Network Retailer to purchase this equipment.

• DISH 322
• DISH Player 522
• DISH Player 625
• DISH Player 942
• ViP 222
• ViP 222k
• ViP 622
• ViP 722
• ViP 722k

• TV2 IR Converter with Sensor
• IR Cable for Slingbox
• Three 10" RG-6 Coax Cable
• Two-Way Splitter
• DC Power Supply
• Installation Manual
• Hook and Loop Fastener

• Converter is used at TV2 with any universal IR or DISH Network IR remote control
  Show Diagram
  
  
  
  
  
• Converter is used to control TV2 with a Slingbox, with independent control of TV2. Note: receiver is in Dual Mode.
  Show Diagram
  
  
  
  
  
• Converter is used to control TV2 with a Slingbox, but independent control of TV2 is not required. Note: receiver is in Single Mode.
  Show Diagram
  
  

• If the Converter is used at TV2 with a DISH Network remote (excluding 222k and 722k)
  
  
  1. Flip the remote's key to show the black UHF side; for replacement remote kits, the silver IR key will also work.
     
     Note: this still controls TV2
     
     
  2. Set the Converter for TV2
     
     Note: If the Converter is used to control a 322, 522, 625 or 942, you must set the Converter to Band A and set the Converter's TV 2/1 switch accordingly.
  
  
  
• If the Converter is used to control a 222k or 722k
  
  
  1. Set the Converter to Band A if the remote used an odd-numbered adderss; set to Band B if the remote uses an even-numbered address; set the Converter's TV 2/1 switch accordingly.
     
     
  2. Leave the remote key as Blue TV2, but set the UHF / IR switch inside the receiver's 21.0 remote controls battery compartment to IR.
  
  
  
• If the Converter is used to control TV2 with a Slingbox, and you also want independent control of TV2, you must set the Converter to TV2 and set the remotes as follows:
  
  
  • TV1's address is set to anything but address 1
    
    
  • TV2's address must be 1 and the Band A/B switch inside the battery compartment on the TV2 remote control must match the A/B switch on the Converter