The 6.2 remote provides extreme flexibility as a replacement remote control.

• Supports many current and past receivers (primarily DVR):
  211, 222, 381, 411, 501/508, 510, 522, 622, 625, 721, 722, 811, 921, 942
• Includes "Identifier Tabs" for remote to be configured as follows:
  • TV1 IR
  • TV1 UHF Pro
  • TV2 UHF Pro
  • UHF Pro
  • IR/UHF
• Easily program Limited Mode - a new process separate from programming the TV or VCR codes.
• Internal A/B switch allows selection between two frequencies to reduce conflicts between dual-tuner receivers (set by pressing Record within System Information screen) How To?
  
  
  Note: All receiver models except the DISH Player-DVR 942 must use switch position A, otherwise the remote control will not work.
  1. Remove the battery cover from the remote control.
  2. Use a small screw driver or a paper clip to carefully change the setting.
  3. Put the battery cover back on the remote control.
  4. Use the SYS INFO button on the front panel to open the System Information screen.
  5. Press RECORD on the remote control.
  6. Make sure the System Information screen shows the correct band information:
     • Switch position A - IR/UHF Pro Band A
     • Switch Position B - IR/UHF Pro Band B
  
  
  • Supported on DISH Player-DVR 942
  • For UHF Pro operation of other receivers, the remote must be in the A position.
• SAT in AUX mode allows you to program the AUX mode button to operate a second DISH Network satellite receiver (via UHF and IR, in most cases). How To?
  
  
  If you have another DISH Network satellite receiver installed, you can use this remote in AUX mode to control it along with your new receiver. When you program the remote to control the other receiver, the remote will send out IR and UHF (not UHF Pro) signals to the receiver. You can program the remote to control any other DISH Network satellite receiver, except for following:
  • TV2 on DISH 322, DISH Player-DVR models 522, 625, and 942
  • DishPlayer 7100/7200
  1. Turn on the other receiver and display the System Info screen. Write down the address shown.
  2. Press and hold the AUX button until all the other mode buttons light up, and then let go of the button. The AUX button flashes.
  3. Press the 3 button.
  4. Use the NUMBER PAD to enter the address you wrote in step 1.
  5. Press POUND (#). The AUX button blinks three times.
  6. Press RECORD to make sure the address and the remote matches the address on the receiver.

Receivers	211/411, 522, 625, 942 TV1	622, 942 only TV1	522, 625 only TV1	522, 625, 942 TV2	211/411, 501, 508, 510, 721	811, 921
Coloring	Green with green 1	Green with black 1	Green with green 1	Blue with black 2	Black	Silver
SAT Mode Sends Out:	IR	UHF Pro Only	UHF Pro Only	UHF Pro Only	UHF & IR	UHF Pro Only
TV/VCR/AUX Mode Sends Out:	IR	IR	IR	IR	IR	IR
SAT In AUX Mode Sends Out:	IR	UHF & IR	UHF & IR	UHF & IR	UHF & IR	UHF & IR

* All Identifier Tabs are double-sided.